Overview
- FMAG-I is used to measure the volumetric flow of conductive fluid in closed pipelines;
- FMAG-I is suitable for DN50～DN3000 pipeline;
- The conductivity of fluid media should not be less than 20μS / cm;
- Changes in pressure, temperature, density and viscosity do not affect the flow measurement of FMAG-I;
- A small amount of solid particles or bubbles in the fluid can also be measured;
- The fixed-length installation type has a simple structure, commissioning and maintenance;
- FMAG-I can be easily installed and removed without stopping water under low pressure;
- The sensor has almost no pressure loss and extremely low energy loss;
- Particularly suitable for large diameter pipeline, with low cost advantages.
Technical Specification
| Nominal Diameter | DN50～DN3000 |
| Electrode Material | 316L, Hb, Hc, Ti, Tan |
| Lining Material | PEEK |
| Dielectric Conductivity | ≥20μS/cm |
| Accuracy Level | ±1.5%R～±3.0%R |
| Flow Range | 0.3m/s～10m/s |
| Ambient Temperature | A：≤80℃；B：≤120℃；C：≤180℃（remote-type） |
| Nominal Pressure | 0.6MPa～1.6MPa (Based on the meter size) |
| Installation Form | Compact/Remote |
| Housing Material | Stainlesssteel316or304 |
| Installation Type | Disassembling without pressure (Fixed-length model) Disassembling with pressure (Pluggable Model) |
| Others | Same as flange-type |